Apply your Jewel Tagz to almost anything - fabrics, wood or paper! Leather does not accept the transfer well. Please test a small sample first. For larger transfers, heat presses are recommended.
|
1. |
Iron on hard flat surface. DO NOT USE IRONING BOARD. |
2. |
Remove backing from transfer and check design to make sure no stones are loose. Adjust stones with tweezers if needed. |
3. |
Place design (sticky side of the transfer) onto fabric in desired location. |
4. |
Place a cloth on top of design to protect fabric. |
5. |
Set iron on medium or wool setting. NO STEAM!! Adjust temperature as needed. If item is thin place a flat piece of cardboard or cloth inside the garment.
|
6. |
Place iron directly on top for 45-60 seconds. Heavier fabrics such as denim may require more time. DO NOT MOVE IRON!!
|
7. |
Allow item to cool, then slowly remove transfer paper. If your design is not sticking to your garment, place transfer back down and re-apply heat.
|
8. |
After transfer paper is removed, turn garment inside-out, place a cloth on inside of garment and repress garment for 15 seconds with 5 seconds of pressure. This will draw glue into the fabric. |
Congratulations!! Your project is now complete! When properly applied, your garment is fully machine-washable and dryable. Turn garment inside out before washing. For best results, dry flat or hang dry. If a stone becomes loose, re-apply heat with iron to re-activate glue. Jewel Tagz is not responsible for garments that do not accept the transfers. |
